anyone using wheel spacers?

I was thinking of putting 10mm spacers on all round, has anyone got this setup? Does it improve handling or make it worse?

In theory it should be better , wider track lower centre of gravity and all that
but the steering will be harder and youl notice more bump steer and theres the bearings to think of, it prob wont fcuk them up but the wear rate will be higher

ok thanks, im gonna give them a go. where can i get extended wheel studs?

Rally spares type site should have them
Just be carfull when takin the old studs out, the hubs aint tough, iv heard of people buckling them, try it out on a knackerd hub 1st

Hi guys,

Is it not safer to by different offset alloys?
So instead of 35-40 offset, you can 25-30. This way you don't need to change hub in case you have a mishap.

It is expensive way of doing it but I think it is easier.

Cheers
Atchi

or get bolt on spacers instead of extended studs

i dont trust those bolt on spacers, rather do it properly.

I want to use the suzuki alloys so its spacers over new wheels.

fuck that get some heat and a scaff bar give it some camber pikey styling

hobo wrote:fuck that get some heat and a scaff bar give it some camber pikey styling

i swear thats not the first iv seen u type this, are u obsessed? lol

haha

yeah its a great idea and its free just like jesse's cutting of springs lol

cutting springs is my new hobbie

dominator wrote:Rally spares type site should have them
Just be carfull when takin the old studs out, the hubs aint tough, iv heard of people buckling them, try it out on a knackerd hub 1st

Best way to get them out is take the hub off, put a wheel nut on and hit the wheel nut with a hammer, pops it out and doesn't damage owt but the wheel bolt.....

Back in it should "grip " in I believe

Im talkin about the hub itself not the studs

Ah ok,

I used a gripper (That what there called?) Like a 4 legged prong that pushes it off